Ergonomic Layout

I have just enough space to rackmount everything. Considering I also have rear rack rails, some less important items can be mounted from the rear. This is all about the ergonomic layout. I may even build some breakout panels for the antenna and audio connectors. I’ll be using a combination of 2U and 3U rack shelves (special thanks to the folks at Gator Rackworks!)  I had to go 3U for some shelves in order to get a useable depth. Most of the radio gear will sit on shelves.

The current layout plan (from top to bottom):

  • ROTOR SHELF       4U
  • AT-AUTO HI           4U
  • AT-AUTO LO           4U
  • 2M RADIO / TNC   1U
  • FLEX VU5K            6U
  • 1K-FA                      4U
  • FLEX 6300             2U
  • FLEX 6700             2U
  • AC POWER             1U
  • PC#1 W7                4U  <<< DESKTOP
  • PC#2 W10              4U
  • PC#3 SERVER        4U
  • ASTRON RS-70      4U

I need the radios and amplifier close to the desktop, placing other ‘less touched’ items either down below or up above. I think the ergonomics are OK at this point.

Before I can start building I have to empty the shack so I can remove all the dust. I have a significant dust problem. And the problem was most apparent as I swapped out the cases on the two production PC’s. Choking on dust.

The plan is to empty the room, and mitigate the dust. I plan to use an air compressor to blow off the dust that’s embedded in the stucco-like ceiling, then, I’ll thoroughly vacuum before having the carpet steam cleaned. Going forward I will employ an oversized HEPA filter in the radio room which will run 24/7 to capture all particulates and hopefully eliminate or at least vastly improve my dust problem.

Back To The Front

Author: K6HR

Licensed since 1994. Active on HF / VHF / UHF / Satellite

Leave a Reply